Advice on cutting sideways in wood with Dremel T-slot cutter

Take a board that is of the right height and make it 15 inches long Cut your groove from end to end using the tips you found Then what you do

Over the years I have used wooden mitre gauge blanks and often been frustrated by the fact that when I first made the jig it was fine, but when I go back to use

how to tell if a slot machine is ready to pay It's a high-speed bit that can handle the 30k RPM, but I'm still not sure how well it will work in my Shapeoko I'm using Fusion 360 to create

how to win big on slot machines BTW, the slot goes thru the board but has an 1 of wood on either end I'm trying to make a tissue box cover This is the top piece Thanks