4 corner idle secondary transfer slot - Don Terrill's Speed-Talk

website holley transfer slot adjustment I always try to have the front & rear blades set as close to each other as possible Set the primaries with the transfer slot squared motor slot art 5 Adjust the spring-loaded bolt and nut until the clearance is eliminated This should require only a slight adjustment to minimize the clearance

holley transfer slot adjustment I drill them to 070 and make sure the holes are drilled on the same side of the plate as the transfer slots, and idle air holes Usually about  Most gasoline carburetors will have the butterflies adjusted with a small length of the idle transfer fuel slot  I drill them to 070 and make sure the holes are drilled on the same side of the plate as the transfer slots, and idle air holes Usually about

Share

Share

Link

Turn off sharing Copy link

See all details