Holley Idle Screws Set At 34 Turns

Holley, mild 502) that I am far far away from the proper idle transfer slot opening I've only got a 2 corner idle setup, but I've played with every

Holley Idle Screws Set At 34 Turns 030 of the transfer slot exposed past the throttle plate at idle Helpful? How do I adjust the pump shot on my carburetor? WITH THE VEHICLE SHUT OFF, look

Holley, mild 502) that I am far far away from the proper idle transfer slot opening I've only got a 2 corner idle setup, but I've played with every

trex slot slot is showing to make it idle All 4 idle mixture screws are turns out Floats are set correctly The carb is a stock unopened Holley

With the Quick Fuel carburetor in place, we discovered that the transfer slot was uncovered by inch to create the desired idle speed But

holley transfer slot adjustment While the carb is off adjust the throttle plate so roughly 040 of the transfer slot is exposed (the slot should appear square once this is

Comments15 · CARB TUNING 101: Tuning basics explained! · Carburetor Transfer Slots